132 Appendix B: NTConfig Windows NT Embedded registry
Manually configuring the Windows NT
Embedded registry
This section discusses how to manually change the Windows
NT Embedded registry entries controlled by Matrox NTConfig
and a few other important registry entries. We recommend
using NTConfig to alter those entries controlled by NTConfig;
this method is much easier than writing directly to the registry
database.
If you choose to write directly in the registry database use
Regedit, the registry database editor, to modify keys of the
registry database directly. Exercise caution when altering the
database with this method because simple mistakes can easily
lead to a configuration that corrupts Windows NT Embedded.
Network components
Note that the registry keys relevant to DAVICOM are only
relevant to Matrox 4Sight units that have a DAVICOM
Ethernet controller. Registry keys relevant to INTEL are only
relevant to Matrox 4Sight units that have an INTEL Ethernet
controller. To identify which Ethernet controller is installed on
the Matrox 4Sight unit, look at the NTConfig dialog box under
the “Enable all network devices and drivers” check box. The
check box will identify the Ethernet controller as soon as
NTConfig can detect it.
To Next Page
Loading...