Remote debugging on Matrox 4Sight using Microsoft Visual Basic 61
Remote debugging on Matrox 4Sight using
Microsoft Visual Basic
Remote debugging is not supported under Windows NT
Embedded for Visual Basic applications.
Working with MIL
When developing a MIL application for Matrox 4Sight, there
are several things to note.
It is important to note that MIL can automatically perform
YUV to RGB transformations and vice versa. MIL performs
these transformations automatically when copying or grabbing
into an image buffer of the required type.
Using the 1394 ports When using the IEEE 1394 ports, you can only use cameras
that are compliant with the IEEE 1394 Digital Camera
Specifications. In addition, once the MIL Matrox Meteor-II
1394 driver is installed, you can only use these cameras through
MIL. Furthermore, MIL does not support the hot-plugging
capabilities inherent in the IEEE 1394 standard.
Using the auxiliary I/Os To use the auxiliary I/Os on Matrox 4Sight from MIL, you must
first assign an interrupt line to the group of I/Os in the BIOS.
These I/Os can then be controlled from within MIL. Refer to the
MIL/MIL-Lite Board-Specific Notes for more information.
Displaying grabbed
images
When displaying grabbed images, the pre-installed Matrox
Meteor-II driver can take advantage of the National
Semiconductor
®
Geode
™
GXLV graphics controller’s overlay
capabilities and use MIL’s DirectDraw underlay-surface
display capabilities. In this mode, Matrox Meteor-II does not
need any CPU intervention to maintain a live image display,
with or without overlay. By default, the Matrox Meteor-II driver
uses this mode.
To Next Page
Loading...