Removing unnecessary files from Matrox 4Sight 63
Removing unnecessary files from
Matrox 4Sight
To achieve a smaller footprint, you can remove unused files
from the Matrox 4Sight unit. Depending on the requirements
of your application, there might be MIL files, installed as
redistribution components of MIL, that can be removed.
To remove all components that are related to Matrox Meteor-II
/Standard when Matrox Meteor-II /Multi-Channel is installed,
use the Met2mc.bat file in Matrox 4Sight’s C:\MIL\BAT
directory.
To remove all components that are related to Meteor-II
/Multi-Channel when Matrox Meteor-II /Standard is installed,
use the Met2std.bat file in Matrox 4Sight’s C:\MIL\BAT
directory.
To remove all components that are not related to Matrox
Meteor-II /1394, use the Met1394.bat file in Matrox 4Sight’s
C:\MIL\BAT directory. This will leave support for only Matrox
Meteor-II /1394 on your unit.
To remove all components that are not necessary for the final
integration of the Matrox 4Sight unit, use the Cl_comp.bat file
in Matrox 4Sight’s C:\MIL\BAT directory. This batch file
deletes all DCF files, RES files, batch files in C:\MIL\BAT,
examples in C:\MIL\EXAMPLES, and the Mildrv utility. After
using this batch file, you must recopy all the DCF and RES files
needed by your application to the Matrox 4Sight unit.
To Next Page
Loading...
