Matrox 4Sight - Page 144

144 Appendix B: NTConfig Windows NT Embedded registry
HKEY_LOCAL_MACHINE\
SYSTEM\
CurrentControlSet\
Services\parallel\Start
Set DWORD to 0 or 4.
Use 4 to deactivate the driver.
Use 0 to activate the Parallel
port driver.
To be used when the
Auxiliary I/O device is
mapped to interrupt line 7
(IRQ 7).
HKEY_LOCAL_MACHINE\
SYSTEM\
CurrentControlSet\
Services\corona\Start
Set DWORD to 0 or 4.
Use 4 to deactivate the driver.
Use 0 to activate the Meteor-II
driver.
To be used when the
Auxiliary I/O device is
mapped to interrupt line 9
(IRQ 9).
HKEY_LOCAL_MACHINE\
SYSTEM\\
CurrentControlSet\\
Services\\DAVICOM\
Start
Set DWORD to 0 or 4.
Use 4 to deactivate the driver.
Use 0 to activate the Davicom
Ethernet driver
DAVICOM ETHERNET
ONLY.
To be used when the
Auxiliary I/O device is
mapped to interrupt line 10
(IRQ 10).
HKEY_LOCAL_MACHINE\
SYSTEM\\
CurrentControlSet\\
Services\\E100E\Start
Set DWORD to 0 or 4.
Use 4 to deactivate the driver.
Use 0 to activate the Intel
Ethernet Driver.
INTEL ETHERNET ONLY.
To be used when the
Auxiliary I/O device is
mapped to interrupt line 10
(IRQ 10).
HKEY_LOCAL_MACHINE\
SYSTEM\
CurrentControlSet\
Services\mtx1394\Start
Set DWORD to 0 or 4.
Use 4 to deactivate the driver.
Use 0 to activate the Meteor-II
1394 driver.
To be used when the
Auxiliary I/O device is
mapped to interrupt line 11
(IRQ 11).
HKEY_LOCAL_MACHINE\
SYSTEM\
CurrentControlSet\
Services\MF1394core\
Start
Set DWORD to 0 or 4.
Use 4 to deactivate the driver.
Use 0 to activate the Meteor-II
1394 low level driver.
To be used then the
Auxiliary I/O device is
mapped to interrupt line 11
(IRQ 11).