Matrox 4Sight - Page 6

Part 2: Making hardware, driver, and OS modifications
Chapter 6: Using the hard drive based Matrox 4Sight. . . . . . . .73
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .74
Removing the Matrox 4Sight chassis . . . . . . . . . . . . . . .75
Connecting to a floppy drive . . . . . . . . . . . . . . . . . . . . .76
Connecting IDE devices. . . . . . . . . . . . . . . . . . . . . . . . .77
Installing a full Windows NT Workstation
on Matrox 4Sight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .78
Installing device drivers . . . . . . . . . . . . . . . . . . . . . .78
Installing an Ethernet driver . . . . . . . . . . . . . . . . . . .80
Installing MIL/ActiveMIL . . . . . . . . . . . . . . . . . . . . . . . .83
Chapter 7: Additions to the Matrox 4Sight integrated unit . . . .85
Additions to the unit . . . . . . . . . . . . . . . . . . . . . . . . . . .86
Connecting an alternate hard drive. . . . . . . . . . . . . .87
Connecting to a flat panel . . . . . . . . . . . . . . . . . . . . .87
Installing a PC/104-Plus
™
board. . . . . . . . . . . . . . . .87
Removing and installing memory
from Matrox 4Sight . . . . . . . . . . . . . . . . . . . . . . . . . . . .89
Removing memory . . . . . . . . . . . . . . . . . . . . . . . . . .89
Installing memory . . . . . . . . . . . . . . . . . . . . . . . . . . .89
Changing DMA memory settings . . . . . . . . . . . . . . . .90
Using the MILConfig utility . . . . . . . . . . . . . . . . . . . .92