Repair Comet Executive Gas
7-22
17. When the entire roll is covered, trim the
right end so that the cover material is even
with the edges of the roll (Figure 7-21).
NOTE: The new padding will be
much thicker. It may be advisable
to follow the appropriate steps
of Compression Roll Pressure
Adjustment on page 7-18
to accommodate this before
proceeding.
18. Re-install the red safety nger guard by
reversing Step 6. Make sure the spacers
and washers are correctly positioned.
Figure 7-21: Trim the material even with the end of
the roll.
19. Close and secure both endframe doors.
WARNING
Never operate the unit unless
all safety covers are in place
and all safety equipment is
working correctly.
20. Turn power ON at the main disconnect
switch.
21. Start the unit and test the red safety nger
guard to make sure the unit comes to a
complete stop when the red safety nger
guard is pushed.
22. Stop the unit.
23. Turn power OFF at the main disconnect
switch.
24. Check and adjust compression roll pres-
sure following Compression Roll Pres-
sure Check on page 7-17 and Compres-
sion Roll Pressure Adjustment on page
7-18.
25. The ironing cylinder must be waxed before
resuming operation. For more information,
Refer to Waxing on page 3-7. Note this
step is not necessary for chrome ironing
cylinders.
To Next Page
Loading...