MELTER OPERATION
4-17
MA-5079-ENG MICRON GEAR ADHESIVE MELTER
Programming equipment activation/deactivation
You may program an activation and a deactivation time for every day of the
week, from Monday (1) to Sunday (7).
Time is expressed in 15 minute increments, so we cycle from 10.0 (10 hours
and 0 minutes) to 10.1 (10 hours and 15 minutes) to 10.2 (10 hours and 30
minutes) to 10.3 (10 hours and 45 minutes).
1. Press the button with the clock symbol
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Use the up-down arrow to select the value for the desired day of the
week, from Monday (1) to Sunday (7).
3. Press the button with the clock symbol once again.
Two times will appear, one in each display. The display on the left
shows the start time, while the display on the right shows the finish
time.
4. The blinking dot next to the start time indicates that this is the value
that may be modified. Use the up-down arrow to select the desired
value.
5. Press the button with the clock symbol once again.
The dot changes to the finish time.
6. Use the up-down arrow to select the desired value.
7. Press the button with the clock symbol once again.
The selected program will appear once again. Use the up-down arrow
to select other programs.
8. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
The green LED next to the ‘ON/OFF’ button will remain blinking as long as
there is an equipment disconnection time programmed for the current day.
To Next Page
Loading...
