MA-5079-ENG MICRON GEAR ADHESIVE MELTER
6-1
TROUBLESHOOTING
6. TROUBLESHOOTING
This chapter shows basic help for solving simple problems without
intervention from Meler technical personnel.
It is very important to respect the security instructions in this manual at all
times. Failure to do so may result in personal injury and/or damage to the
machine or to the rest of the installation.
Warning: The melter/applicator equipment is equipped with current
technology, but with certain foreseeable risks. Therefore, only allow
appropriate personnel with enough training and experience to use, install or
repair this equipment.
Each observed problem corresponds to a chapter section. There are four
different columns in each one:
• Possible causes.
• Verification to be performed.
• Useful observations.
• Actions.
The system is simple. Locate the chapter section that corresponds to the
observed problem. Starting from the column on the left, follow vertically the
causes. Once the cause is found check, the action is performed taking into
account the comments and once the error checked carried out in each case
corrective action.
If you do not reach the cause follow to the next problem.
If you are unable to solve the problem with the help provided in this chapter,
contact your Area Technical Service Center or Meler headquarter directly.
To Next Page
Loading...
