MELTER OPERATION
4-19
MA-5079-ENG MICRON GEAR ADHESIVE MELTER
Two times will appear, one in each display. The left display shows the
start time, while the right display shows the finish time.
5. The blinking dot next to the start time indicates that this is the time
that may be modified.
Use the up-down arrow to select the desired value.
6. Press the button with the clock symbol once again.
The dot changes to the finish time.
7. Use the up-down arrow to select the desired value.
8. Press the button with the clock symbol once again.
The selected program appears once again. You may use the up-down
arrow to select other programs.
9. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
The green LED next to the ‘maintenance’ button will remain blinking as long
as there is an equipment standby function activation time programmed for the
current day.
Disabling the equipment standby function programming
It is possible to disable the equipment standby function programming without
canceling the daily programming. This way the programmed data is saved,
but the programming will have no effect on the equipment.
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Press the standby function button.
A ‘1’ will appear, indicating the first day in the standby function pro-
gramming.
3. Use the up-down arrow to go past the selection for the last day of the
week (7).
The message ‘ON/OFF’ will appear on the display, depending on the
current status.
To Next Page
Loading...
