FOCKE MELER GLUING SOLUTIONS
4-18
MELTER OPERATION
Disabling the equipment activation/deactivation program
It is possible to disable the equipment activation/deactivation programming
without canceling the daily programming. This way the programmed data is
saved, but the programming will have no effect on the equipment.
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Use the up-down arrow to go past the selection for the last day of the
week (7).
The message ‘ON/OFF’ will appear on the display, depending on the
current status.
3. Press the button with the clock symbol once again.
The status will alternate each time you press the button.
4. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
Programming the equipment’s standby function activation/deactivation
You may program an activation and a deactivation time for every day of the
week, from Monday (1) to Sunday (7).
Time is expressed in 15 minute increments, so we cycle from 10.0 (10 hours
and 0 minutes) to 10.1 (10 hours and 15 minutes) to 10.2 (10 hours and 30
minutes) to 10.3 (10 hours and 45 minutes).
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Press the standby function button.
A ‘1’ will appear, indicating the first day in the standby function pro-
gramming.
[Since the current time and date are values common to both programs,
the value ‘0’ does not appear in this menu].
3. Use the up-down arrow to select the desired value for the day of the
week, Monday (1) to Sunday (7).
4. Press the button with the clock symbol once again.
To Next Page
Loading...
