90-826148R2 MARCH 1997 MID-SECTION - 5B-37
3. Use the (.060 wire) removal tool (see previous
page) and push out the spool and one seat.
4. From opposite side, use a punch and push out
the remaining seat.
a
b
c
d
e
d
c
b
a
a - Plug (2)
b - Spring (2)
c - Poppet Assembly (2)
d - Seat (2)
e - Spool (1)
IMPORTANT: Inspect poppet assemblies for de-
bris in the area shown. If debris is found on pop-
pets replace poppets.
a
b
a - Debris Under Valve Tip
b - Rubber Seat
Cleaning/Inspection/Repair
IMPORTANT: Components must be dirt and lint
free. Slightest amount of debris in Power Trim
system could cause system to malfunction.
Clean shock rod and components with parts cleaner
and dry with compressed air.
It is recommended that all O-rings in trim system be
replaced. Use O-Ring Kit 25-827668A1.
Lubricate all O-rings with power trim fluid.
Trim Motor Electrical Tests
1. Connect a 12 volt supply to motor leads. If motor
fails to run, replace pump motor.
IMPORTANT: Trim Motor is not serviceable. If mo-
tor fails to run, replace motor assembly
To Next Page
Loading...
