2C-2 - ELECTRICAL 90-826148R2 MARCH 1997
Tiller Handle Model
(S/N-0G589999 & Below)
1. With engine off and gear shift in neutralposition,
loosen cam follower screw.
2. Backoffidlespeedscrewuntilthethrottleshutter
positioner does not touch the taper of idle speed
screw. (Throttle plate closed).
3. Loosen throttle cable jam nuts.
52301
a
b
c
d
a - Cam Follower Screw
b - Throttle Shutter Positioner
c - Jam Nut
d - Idle Speed Screw
4. With throttle at idle position, place cam follower
roller against throttle cam. Center the roller with
raisedmarkonthrottlecambyadjustingtheposi-
tion of throttle cable sleeves in the mounting
bracket.
NOTE: When positioning throttlecables, a minimum
of 1/16 in. (1.59 mm) to a maximum of 1/8 in. (3.18
mm)slackmust beallowed to preventthrottlecables
from binding. (Rock throttle cam side to side and
measure the amount of throttle cam travel at link rod
ball.
5. Tighten throttle cable jam nuts.
52300
a
b
c
d
e
d
a - Cam Follower Roller
b - Throttle Cam
c - Mounting Bracket
d - Throttle Cable Sleeve
e - Cam Follower Screw
Cable Slack
Min. 1/16 in. (1.59 mm)
Max. 1/8 in. (3.18 mm)
52300
a
b
a - Throttle Cam
b - Link Rod Ball
6. With cam followerresting onthrottlecam,tighten
the cam follower screw.
To Next Page
Loading...
Need help?
General
