© Microhard Systems Inc. 127
4.0 Configuration
4.10.5 GPS > Recorder
The BulletPlus can be configured to record events based on time intervals, and/or an event trigger and
store them in non-volatile memory. These events can then be viewed within the WebUI, on a map, or sent
to a remote server in a number of different formats.
Image 4-10-6: GPS > GPS Recorder Service
Status
Use the Status parameter to enable the GPS recording functionality of the
BulletPlus. The total number of records that can be recorded varies
between 16,000 and 36,000, depending on the number of GPS parameters
that are recorded.
Values (selection)
Disable
Enable GPS Recorder
Time Interval
Define the interval at which the BulletPlus will record GPS data. If there is
no valid data available at the specified time (i.e. no connected satellites),
the unit will wait until the next time valid information is received.
Values (seconds)
300
DI/DO Changed
The BulletPlus can detect and report the current GPS info when a digital
input or output status changes, regardless of the time interval setting.
Values (selection)
Record / Don’t Record
To Next Page
Loading...
