Microhard Systems BulletPlus - SMS Commands

© Microhard Systems Inc. 62
4.0 Configuration
This option allows a user to enable or disable to use of the following
SMS commands to reboot or trigger events in the BulletPlus:
Status
Values (Selection)
Enable / Disable
If enabled, the BulletPlus will only accept and execute commands
originating from the phone numbers in the Phone Filter List. Up to 6
numbers can be added.
Set Phone Filter
Values (Selection)
Enable / Disable
MSC#REBOOT Reboot system
MSC#NMS Send NMS UDP Report
MSC#WEB Send web client inquiry
MSC#MIOP1 open I/O ouput1
MSC#MIOP2 open I/O ouput2
MSC#MIOC1 close I/O ouput1
MSC#MIOC2 close I/O ouput2
MSC#EURD0 trigger event report0
MSC#EURD1 trigger event report1
MSC#EURD2 trigger event report2
MSC#EURD3 trigger event report3
MSC#GPSR0 trigger gps report0
MSC#GPSR1 trigger gps report1
MSC#GPSR2 trigger gps report2
MSC#GPSR3 trigger gps report3