Microhard Systems BulletPlus - Page 173

© Microhard Systems Inc. 173
5.0 AT Command Line Interface
AT+MNLANSTP
Command Syntax (Effect: AT&W)
Get/Set the network LAN interface: Spanning Tree
(STP)
AT+MNLANSTP=<LAN Name>[,<STP>]
Parameters:
LAN Name: Name of Network LAN interface
Spanning Tree: 0 - Off
1 - On
Description
Example
Input:
AT+MNLANSTP=lan,0<enter>
Response:
OK
AT+MNLANDNS
Command Syntax (Effect: AT&W)
Get/Set the network LAN interface: DNS
AT+MNLANDNS=<LAN Name>[,<Mode>
[,<Primary DNS>,<Secondary DNS>]]
Usage:
AT+MNLANDNS=<LAN Name>
AT+MNLANDNS=<LAN Name>,<Mode>
Where <Mode>=0
AT+MNLANDNS=<LAN Name>,<Mode>
[,<Primary DNS>,<Secondary DNS>] Where
<Mode>=1
Parameters:
LAN Name: Name of Network LAN interface
Mode: 0 - Auto
1 - Manual
Primary DNS: Valid IP Address or 0 (Reset)
Secondary DNS: Valid IP address or 0 (Reset)
Description
Example
Input:
AT+MNLANDNS=lan,0<enter>
Response:
OK