Microhard Systems BulletPlus - Page 175

© Microhard Systems Inc. 175
5.0 AT Command Line Interface
AT+MNWANDR
Command Syntax (Effect: AT&W)
Get/Set the network WAN interface: Default Route
AT+MNWANDR[=<Default Route>]
Parameters:
Default Route : 0 - No
1 - Yes
Description
Example
Input:
AT+MNWANDR=1<enter>
Response:
OK
AT+MNWANDNS
Command Syntax (Effect: AT&W)
Get/Set DNS Server when WAN port set as
Independent WAN.
AT+MNWANDNS[=<Mode>[,<Primary
DNS>,<Secondary DNS>]]
Usage:
AT+MNWANDNS
AT+MNWANDNS=<Mode> Where <Mode>=0
AT+MNWANDNS=<Mode>[,<Primary DNS>,
<Secondary DNS>] Where <Mode>=1
Parameters:
Mode: 0 - Auto
1 - Manual
Primary DNS: Valid IP Address or 0 (Reset)
Secondary DNS: Valid IP address or 0 (Reset)
Description
Example
Input:
AT+MNWANDR=0<enter>
Response:
OK