Microhard Systems BulletPlus - Page 185

© Microhard Systems Inc. 185
5.0 AT Command Line Interface
AT+MFRULE
Command Syntax
Get/Set firewall rule.
AT+MFRULE[=<Name>[,<Operation>[,<Action>,<Source>,<Src IP Format>,<Src IP From/Subnet >,<Src IP To/Prefix>,
<Destination>,<Dest IP Format>,<Dest IP From/Subnet>,<Dest IP To/Prefix>,<Dest Port>,<Protocol>]]]
Parameters:
Name: Name of firewall rule name, 1 - 64 characters
Operation: ADD - Add a firewall rule
EDIT - Edit a firewall rule
DEL - Delete a firewall rule
Action: 0 - Accept
1 - Drop
2 - Reject
Source: 0 - LAN
1 - Independent LAN
2 - WAN
3 - Carrier
4 - WIFI
5 - None
IP Format: 0 - IP Range
1 - Subnet / Prefix
IP From/Subnet: Valid IP address. 0 - Set to blank
IP To/Prefix: Valid IP address. 0 - Set to blank; or 0 ~ 32 for Prefix
Destination: 0 - LAN
1 - Independent LAN
2 - WAN
3 - Carrier
4 - WIFI
5 - None
IP Format: 0 - IP Range
1 - Subnet / Prefix
IP From/Subnet: Valid IP address. 0 - Set to blank
IP To/Prefix: Valid IP address. 0 - Set to blank; or 0 ~ 32 for Prefix
Port/Range: Port 0 ~ 65535 or Port range specified as 100:200 format
Protocol: 0 - TCP
1 - UDP
2 - TCPUDP
3 - ICMP
4 - GRE
Description
Example
Input:
AT+MFRULE=rule1,ADD,0,3,0,0,0,5,0,0,0,34567,2<enter>
Response:
OK
Input:
AT+MFRULE?
Response:
Name : rule1
Action : ACCEPT
Source :
Src IP From :
Src IP To : 0
Destination :
Dest IP From :
Dest IP To : 0
Dest Port : 34567
Protocol : tcpudp
OK