Microhard Systems BulletPlus - Page 192

© Microhard Systems Inc. 192
5.0 AT Command Line Interface
AT+MIOSTATUS
Command Syntax
GET IO status.
AT+MIOSTATUS <enter>
Description
Example
Input:
AT+MIOSTATUS <enter>
Response:
+MIOSTATUS: IO status
iodigiinval1=High
iodigiinval2=High
OK
AT+MIOMETER
Command Syntax
GET IO meter (V).
AT+MIOMETER <enter>
Description
Example
Input:
AT+MIOMETER <enter>
Response:
+MIOMETER: IO meter(V)
iovolts1=2.77
iovolts2=2.81
OK
AT+MCPS2
Command Syntax (Effect: AT&W)
Configure the Serial port as either a console port
(AT Commands) or a Data Port.
AT+MCPS2=<Mode>
Mode:
0 Console
1 Data
Description
Example
Input:
AT+MCPS2=0<enter>
Response:
OK