Microhard Systems BulletPlus - Page 54

© Microhard Systems Inc. 54
4.0 Configuration
Select which WAN connection is the secondary connection. When a
failure of the main WAN occurs this will be the first alternative.
Generally this will be the cellular connection.
Second WAN
Values (selection)
WAN / 4G / WIFI
Third WAN
The WiFi on the BulletPlus can be configured as a client and used as a
data connection to access the internet.
Values (selection)
WAN / 4G / WIFI / Disable
Host Name
Up to three(3) reachable addresses can be specified to test for link
health at the frequency specified above for the Health Monitor Interval.
A test button is provided to ensure that reachable address have been
entered and that there are no errors.
Values (Address)
8.8.8.8
4.2.2.1
208.67.222.222
Health Monitor Interval
This is the frequency at which the BulletPlus will send ICMP packets to
the defined host to determine if the interface has failed.
Values (seconds)
20
Switch Notification
It is possible for the BulletPlus to send out a notification when the
MultiWAN has switched its available connection and is routing data
through an alternate interface.
Values (selection)
Disable / Email / SMS / Both
Primary WAN
Define which connection is the primary network/internet connection for
the BulletPlus. Normally this is the wired WAN connection to an ISP.
Values (selection)
WAN / Carrier / WIFI Client
Type
Select the type of failover detection to be used. By default ICMP is
used to ping a specified address(s), a DNS Lookup can also be
selected.
Values (selection)
ICMP / DNS Lookup
Failover Settings (Same settings for WAN, WIFI Client and Carrier)
Advanced+ (Only shown if selected)