© Microhard Systems Inc. 60
4.0 Configuration
Use this interface as the default route for all outbound traffic unless
specified in the Network > Routes table.
Default Route
Values (Selection)
Yes / No
If enabled the Bullet with use the DNS server as specified
automatically by the service provider.
Use Remote DNS
Values (selection)
Enable / Disable
Network+
In some cases the Static IP address must be entered in this field if
assigned by a wireless carrier. In most cases the IP will be read from
the SIM card and this field should be left at the default value.
IP Address
Values (IP Address)
(none)
When enabled DNS-Passthrough will pass on the WAN assigned DNS
information to the end device.
DNS-Passthrough
Values (Selection)
Enable / Disable
SIM Card-2 Settings
Settings for SIM Card-2 are identical to that of SIM Card-1, refer to the previous section for information on
how to configure SIM Card-2.
A User Name may be required for authentication to a remote peer.
Although usually not required for dynamically assigned IP addresses
from the wireless carrier. Varies by carrier.
User Name
Values (characters)
Carrier/peer dependant
Enter the password for the user name above. May not be required by
some carriers, or APN’s
Password
Values (characters)
Carrier/peer dependant
To Next Page
Loading...
