Selecting scope parameter sections 195
PRO6 Live Audio System
Owner’s Manual
>> To select a single parameter section
1 Click SINGLE.
2 Click the desired parameter section.
In some cases more than one parameter section may be selected. This may occur if:
• The parameter section belongs to a channel that is stereo linked. The equivalent
parameter section of the other paired channel will also be selected.
• Other channels are patched to the same source as the channel in which you are
making your selection. This only applies to the All and Mic Amp parameter
sections.
>> To select a parameter section in all channels of a single type
1 Click BY CHANNEL TYPE.
2 Click the desired parameter section in any channel of
the type you want. For example, click the routing
parameter section in any of the input channels. The
routing parameter section on all input channels will
be selected (as shown right).
>> To select all of the parameters of a single channel
1 Click INDV. CHANNEL.
2 Click any parameter section in the channel you want. For
example, click the All parameter of input channel 5; all the
parameter sections in channel 5 are selected (as shown right).
If the channel is stereo linked, all of the parameter sections in its paired
channel will also be selected.
To Next Page
Loading...
Need help?
General
