Aux 513
XL8 Live Performance System
Owner’s Manual
Dynamics
The following diagram shows the compression parameters of the dynamics section
affected by stereo linking. Only corrective compressor shown below, but this is typically
the same for the other compressor modes.
Note: Only the corrective compressor is shown above, but this is typically the same for
the other compressor modes (adaptive, creative, vintage and shimmer).
Item Control Parameter
1 DYN/[CMP] switch Compressor on/off
2 release control knob Compressor release
3 threshold control
knob
Compressor threshold
4 KNEE pushbutton Compressor knee: hard, medium or soft
5 IN switch Compressor sidechain in/out
6 freq. control knob Compressor sidechain frequency
7 WIDTH pushbutton Compressor sidechain width: 2 Oct, 1 Oct or
0.3 Oct
8 ratio/range/[ratio]
control knob
Compressor ratio
9 attack control knob Compressor attack
3
Compressor
processing area in
GUI channel strip
aux send
overview in GUI
channel strip
3
11
5
6
7
2
10
9
8
4
10
9
8
4
3
11
2
5
6
7
1
1