Automatic c Select this function to call up the Automatic programmes. Auto
-
matic programmes are available with and without the addition of
moisture.
The Automatic programmes will vary depending on model. All the
recipes in this book can also be cooked without using an Auto
-
matic programme. The settings are listed under "Alternative
settings".
Moisture plus
d
Depending on recipe you can choose between
– Automatic burst of steam
– 1 burst of steam, 2 or 3 bursts of steam
Bursts of steam 1, 2 and 3 can be released either manually or
automatically.
Manually If you want to release the bursts of steam manually,
you can set the minute minder N to remind you when
to do so.
If you are using the Moisture plus programme and
the recipe requires the oven to be pre-heated, you
will need to release the steam manually.
The time to release the 1st burst of steam will
depend on:
– the start time for the programme when the oven is
not pre-heated
– when the food goes into the oven with a
pre-heated oven.
The time quoted for the next burst of steam is always
the duration since the last burst of steam was
released.
Time
controlled
If you want Time controlled steam release, you will
need to specify the time at which each burst of steam
is released before the cooking programme starts.
Factory
default
heating
method
The Moisture plus programme uses "Fan heat"
together with the addition of moisture.
For most recipes you will not need to change this
setting.
Other
heating
methods
If the recipe recommends using a different type of
heat to "Fan plus" this will be specified in the settings
chart for the recipe.
Settings
8
To Next Page
Loading...
