MM098-002 – LOGOS ONE – Operator Manual
93
The following message appears every time a program is started, read carefully the message on the screen
and press OK to start the process.
The following logic is for every phase:
If previous reagent exist
Timed loading previous reagent
If previous reagent do not exist
So if the phase is the first, the previous reagent does not exist, this is the reason why it is it is necessary that
operator stays close to the unit at the beginning of a new process until loading of the first reagent is
completed and the graph is displayed on the screen, this lasts no more than 2 minutes in normal conditions.
To assure safety of samples, in fact, it is necessary that operator stays close to the unit at
the beginning of a new process until loading of the first reagent is completed and the
graph is displayed on the screen.
LOADING COMPLETED
UNIT CAN NOW BE UNATTENDED
To Next Page
Loading...
