163
8. DISPOSING OF THE UNIT
This instrument is usually installed in a laboratory where specimens and other biological tissues are present.
For your safety, you must therefore clean and decontaminate it before coming into contact with it. You must
wear gloves when operating the system.
In case of return, the unit must be cleaned and decontaminated before sending it back to Milestone. Non-
decontaminated devices will not be accepted and you will be required to pay the relative decontamination cost.
International health rules require that shipments of biohazard materials are not done in standard packages
(risk of sanctions).
For further information, please contact the manufacturer: application@milestonemedsrl.com.
Removal of the equipment for disposal:
1) Switch off the appliance. Disconnect the socket.
2) Disconnect all optional parts connected to the unit, if any.
3) Clean and decontaminate all parts of the equipment according to the manufacturer’s specifications.
4) Remove all electric and electronic parts of the equipment.
In compliance with directive 2012/19/EC of the European Parliament of 4 July 2012 on waste electrical and
electronic equipment (WEEE), the separate collection of equipment is mandatory.
It is required to return the used equipment to the distributor or to inquire about the presence of a local system
for collection and disposal of electrical and electronic equipment.
Failure to comply with Directive 2012/19/EC may have a potential impact on the environment and human
health.
This symbol indicates separate collection for electrical and electronic equipment.
If additional requirements on accident prevention and environmental protection exist in the country of
operation, this instruction manual must be supplemented by appropriate instructions to ensure compliance
with such requirements.
To Next Page
Loading...
