MM182-001 – Operator Manual
57
2.5.8. Connection to the hydraulic system – Water inlet
Connect a suitable pipe to each of the two 1/2’’ female fittings at the pressures indicated in this manual.
Connect the hot water to the inlet marked red and connect the cold water to the inlet marked blue. If you only
want to use one of the two inlets, plug the unused inlet with the supplied cap.
Maximum pressure 0.6 bar. The water connection points move with the work surface,
therefore use pipes suitable for movement.
Milestone suggests mounting a tap upstream of the water inlet if the hood needs to be
accessed for maintenance.
If pressure exceeds the data indicated in this chapter, use a pressure regulator, like the one
indicated in the optional parts in chapter 5.19.
Fluid temperature MIN: +2 °C MAX 52 °C.
Check that there are no water leaks owing to vibrations during transport, in the final section
of the tap.
Milestone suggest using a water softener to avoid scale deposits and mounting a tap
upstream of the water inlet.
To Next Page
Loading...
