64
As shown in the figure, two pipes are channeled to the cap.
Screw the cap of the new tank.
When the pedal is pressed , the fixative passes through one of the two pipes to then come out of the
specific dispenser on the front panel of the unit, marked with the supplied symbol (only
for Formaldehyde).
The second pipe is connected to the ventilation system.
The figure shows how to plug the tank with a specific stop by using the knob.
You may use the metal tank protection cable supplied with the unit.
Pass the cable through the handle of the tank and then into the slot of the cable to form a noose. Insert the pin
into one of the four specific slots of the tank holder, as shown below.
Turn the key to lock/unlock it (store the key in a safe place).
To Next Page
Loading...
