MM182-001 – Operator Manual
66
There is a filling sensor on the cap of the waste tank. When the maximum level is reached, a beeper and visual
indication are triggered both on the sensor and on the terminal of the unit, as explained in chapter 2.6.
When the software on the terminal communicates it, empty the tank in an appropriate
container according to current regulations. NEVER drain into the tank when the software
indicates that it is full, as this might lead to fluid leakage.
When replacing the used fixative tank, pay attention not to wet the UltraGROSS lifting
columns.
Only drain the reagents shown in chapter 1.4.
Unscrew the lid to empty the tank and reposition it properly.
Before replacing the used fixative tank, raise the work surface all the way to allow residual
fixative in the pipe to flow out into the tank.
To Next Page
Loading...
