78
• Faulty right exhaust – CODE 3
(this appears for example when the pressure switch does not work properly)
1. Press ‘Silent’.
2. Check the air speed thresholds in General settings.
3. Press + and – to set the correct air speed (only if there is a motor).
4. Press 'Clear' to cancel the alarm.
5. Contact customer support if the problem cannot be solved.
• Motors thermal overload – CODE 4
1. Press 'Clear' to reset the alarm.
2. Contact customer support if the problem cannot be solved.
• Glass Open – CODE 5
1. Close the front shield.
2. Contact customer support if the problem cannot be solved.
• Air speed out of range – CODE 6
(this appears for example when outside of the in General settings thresholds)
1. Press ‘Silent’.
2. Check the Speed thresholds in the General software settings.
3. Press + and – to set the correct air speed (only if there is a motor).
4. Press 'Clear' to reset the alarm.
5. Contact customer support if the problem cannot be solved.
• Exhaust fault– CODE 7
1. Press 'Clear' to reset the alarm.
2. Contact customer support if the problem cannot be solved.
• Charcoal filter expired – CODE 10
1. Press ‘Silent’.
2. Call customer support to replace the filter.
• HEPA filter expired - CODE 11
1. Press ‘Silent’.
2. Call customer support to replace the filter.
• Internal filters expired - CODE 12
1. Press ‘Silent’.
2. Call customer support to replace the filter.
• Tank left full – CODE 13
1. Wear the dedicated PPE.
2. Lift the unit to the maximum height.
3. Empty the full tank.
4. Contact customer support if the problem cannot be solved.
• Tank right full – CODE 14
1. Wear the dedicated PPE.
2. Lift the unit to the maximum height.
3. Empty the full tank.
4. Contact customer support if the problem cannot be solved.
To Next Page
Loading...
