6 Image Acquisition
Operator’s Manual 6 - 7
Rotation/Flip
This function provides a better observation for image display.
• Invert: To invert the image horizontally or vertically.
Tap [U/D] or [L/R] on the touch screen to adjust the parameters.
• Rotation: Image can be rotated by the manners in angle of 0°, 90°, 180°, 270°.
The “M” mark indicates the orientation of the image; the M mark is located on the top of the
imaging area by default.
iBeam
This function is used to superimpose and average images of different steer angles to obtain image
optimization.
iBeam is disabled when it is off.
The phased probe does not support iBeam. iBeam is unavailable when ExFov is enabled.
Auto Merge
In the Dual-split mode, when the images of the two windows have the same probe type, depth,
invert status, rotation status and magnification factor, the system will merge the two images so as to
extend the field of vision.
Only for linear probes.
Gray Map
Adjusting grayscale contras to optimize the image.
Tint Map
This function provides an imaging process based on color difference rather than gray distinction.
TSI
The TSI function is used to optimize the image by selecting acoustic speed according to tissue
characteristics.
HDScope
The image inside the ROI is clearer than these outside when the function is enabled.
• When the ROI box is solid line, roll the trackball to change its position.
• When the ROI box is dotted line, roll the trackball to change the size.
• Press <Set> to switch between the solid line and the dotted line status.
Off represents the disable. The larger the value is, the clearer the image becomes.
The function is disabled in frozen state.
iTouch
+
To optimize image parameters as per the current tissue characteristics for a better image effect.
It is available for all real-time imaging in B mode.
To Next Page
Loading...
