4 Setup
Operator’s Manual 4 - 39
4.9 Print Preset
This screen is used to set up the printer and image printing.
4.9.1 Print Setting
4.9.2 Image Settings
Click [Image Setting] to enter the page, you can set the brightness, contrast and saturation of image
printing, or you can use the default values.
4.10 Maintenance
The [Maintenance] function is designed for you to import or export user data, restore factory setting
and export log. You may also execute self-test and option installation/trial through the maintenance
menu. Furthermore, you can set the factory preset, export the register data, and etc.
If you require other maintenance functions, please contact Mindray Customer Service Department
or sales representative.
4.10.1 Option
The system enters the Option page after entering the Maintenance screen. In the Option list, the
system lists all the system-supported options and their installation status (not installed or installed).
Please contact the Mindray Customer Service Department or a sales representative for details.
4.10.2 Exporting Setup Data
This function is used to write all setup data of the system into a disk for backup. The format of the
data file is .PDP.
You can select 2 types of preset data to export from the system:
• General module preset data: including “All Preset”, “Image Preset”, “iWorks Preset” and
“DICOM/HL7” data.
• Exam mode related preset data, including all image setting, comment and body mark setting
and measurement setting data.
Perform the following procedure:
MIOT Service Switch On Click to enable MIOT service.
Item Description
Item Description
Add Service Click to begin adding print services.
Remove Service Click to delete the selected print service.
Rename Service Click to rename the selected print service.
Default Print Service Click to set the selected print service as the default one.
Property Preset print service properties.
To Next Page
Loading...
