7 - 18 Operator’s Manual
7 3D/4D
3. Tap [3D] or press the user-defined <3D> key to enter Smart 3D image acquisition preparation
status.
4. Adjust ROI size and position and the position of VOI.
5. Select the render mode. Set the scan method and the movement of the probe (angle and
distance).
6. Press <Update> to start 3D imaging.
7. The system enters into 3D image review status when the acquisition is completed; or, you can
finish the acquisition ahead by pressing <Freeze> or <Update>.
NOTE:
In image review status, you can perform the same operations as in Static 3D.
8. Exit Smart 3D
– Press <Update> or <Freeze> to return to Smart 3D acquisition preparation status.
– Or press <B> to exit the mode.
7.6.2 Smart 3D Acquisition Preparation
The smart 3D acquisition preparation is same with these in Static 3D and 4D.
7.7 iLive
iLive brings you a better imaging experience by adding a light rendering effect to the traditional
method. It supports the point lighting mode, parallel lighting mode as well as the torch lighting
mode, allowing human tissue texture to be revealed more clearly.
iLive is available under Smart 3D, Static 3D and 4D modes. To use the iLive function, you must
configure the Smart 3D module or the 4D.
To Activate iLive
Perform the following procedure:
1. Enter 3D/4D image viewing status, or double-click the saved 3D/4D cine file in the iStation or
Review screen.
2. Tap [iLive] under the [Adv.] page on the touch screen to turn the function on, and adjust the
parameters.
Parameter NOTE
3D/4D Scenario Setting Select 3D/4D scenario based on different scenario application.
Method Select the image acquisition method. The speed is related to scanning
distance or angle.
Distance To set the distance the probe covered from one end to the other end
during the linear sweep.
Angle To set the motion angle the probe covered during a fan sweep.
Acquiring Time To set the acquiring time of the Smart 3D acquisition.
To Next Page
Loading...
