Mindray Consona N6 - 4.8.4 Router Setting; 4.8.5 MIOT Preset

4 - 38 Operator’s Manual
4 Setup
Perform the following procedure:
1. Select “Enable Q-Path”.
2. Enter the website, account and password of the target service.
3. Select user type: Personal User or Default User.
– Personal User: the personal user needs to enter the user name and password in every-time
login.
– Default User: after the default user enters the user name and password in the field box of
the “User Name” and “Password”, and click [OK], no login is required to access the Q-
Path server later.
4. Select an appropriate item from the drop-down list of “Available Items”.
5. Select an exam mode in the left “Exam Mode” column.
6. Select a worksheet in the right “Worksheets” column.
7. Click [OK] to exit, and the system will shut down.
4.8.4 Router Setting
Set the route if the ultrasound system needs to be connected to the Internet and there are more than
two access modes (for example, the ultrasound system can be connected to the Internet in wireless
or wired mode).
Auto
After the Internet access mode is selected, the default gateway and DNS server will be
automatically configured.
Perform the following procedure:
1. Select [Setup] > [Network] > [Router Setting] > [Auto].
2. Select the access mode from the drop-down list, and click [OK].
NOTE:
You need to select a specific access mode. You cannot select “None.”
3. Click [OK] to exit.
Static Routing
Manually configure the static route if the ultrasound system needs to access an LAN different from
the same network segment, after setting up the Internet access mode on the [Auto] page.
4.8.5 MIOT Preset
After the MIOT (Mindray Internet of Things) service is enabled and configured, the Ultrasound
device information such as Usage, Operating duration, can be transmitted to MIOT.
Load Factory Restores the worksheet template to the default state.
Item Description
Item Description
IP Address IP address of the MIOT service device.
Port Port for transmitting.