14 - 8 Operator’s Manual
14 Measurement, Comments and Body Mark
Library
Tap [Library] to select the body mark library, the corresponding body marks are shown on the left.
Page-turning
If there is more than one page, slide the touch screen to turn the page.
Save Probe
Under the condition that the probe mark direction and position is determined for the current adding
body mark, tap [Save Probe] to save the current direction and position for the probe mark of the
current body mark.
14.4.2 Adding Body Mark
Perform the following procedure:
1. Press [Body Mark] to enter the Body Mark status.
2. Tap the desired body mark on the touch screen directly.
3. To adjust the probe position and orientation marker.
– Use the trackball to place the probe marker at the correct position.
–
Rotate <Angle
> to adjust the
mark’
s direction
.
– Tap [Save Probe] to save the current direction and position for the probe mark of the
current body mark.
4. Press <Set> to confirm the position and orientation of the probe marker and exit the body mark
mode.
14.4.3 Moving Body Marks
You can move the body mark graphics to any desired position within the image area.
In Dual B Mode, a Body Mark cannot be moved between the separate image windows.
Perform the following procedure:
1. Press <Cursor> and move the cursor onto the body mark. The cursor then becomes ,
indicating you can move the Body Mark graphic to a new position.
2. Press <Set> to select the body mark.
3. Move the Body Mark graphic to the desired position.
4. Press <Set> to anchor and confirm the new graphic position.
14.4.4 Deleting Body Marks
• Preset returning, switching the exam mode/patient/probe will clear the body marks.
• Set if body mark is erased when the image is unfrozen, see “4.1.4 Application”.
Perform the following procedure:
1. Press <Cursor> and move the cursor onto the body mark. The cursor then becomes .
2. Press <Clear> to delete the body mark.
To Next Page
Loading...
