4 Setup
Operator’s Manual 4 - 17
The following takes Auto Trace as an example to show how to set the properties of a
measurement tool.
a. Select the [Doppler] tab to go to the corresponding preset menu.
b. Select [Auto Trace] from the [Selected Items] and click [Property] to bring up the
following dialog box.
Descriptions of the attributes are shown in the following table:
c. Click [OK] to confirm the setting.
7. Select the measurement sequence.
– [Repeat]: after the current measurement is completed, the system automatically activates
the current tool again.
– [Next]: after the current measurement is completed, the system automatically activates the
next tool in the menu.
– [None]: after the current measurement is completed, the cursor can be moved over the
whole screen. And the cursor will automatically return to the menu of the corresponding
measurement.
8. Click [OK] to confirm.
4.3.2 Application Measurement Preset
Measurement Package Preset
During measurement, the preset package displays on the touch screen. Items in the package can be
preset and may belong to different application regions.
Item Description
Item Name & Result Results obtained from Auto Trace are listed. The selected items will be
displayed in the results window after measurement.
Unit Select the measurement unit.
Click “Unit” column of each item to select.
CalcMethod Select the measurement method for the tool.
Click “CalcMethod” column of each item to select.
To Next Page
Loading...
