14 - 6 Operator’s Manual
14 Measurement, Comments and Body Mark
14.2.5 Deleting Comments
Deleting Comments Characters, Texts or Arrows
Perform the following procedure:
1. Move the cursor to the comments to be deleted.
2. Press <Set> to select the comment.
3. Tap [Delete Word] or press <Clear> to complete the deletion.
Deleting a recently-added character, text or arrow
Perform the following procedure:
1. In comment status, press <Clear> to delete the latest added/modified comment unit.
2. Enter letters by pressing the alphanumeric key on the keyboard and use blank key to divide the
letters. Tap [Delete Word] to delete latest added/modified comment unit and enter comment
status.
Delete letters one by one
In comment editing status, use on the keyboard to delete letters before cursor “|”.
In comment editing status, use <Del> on the keyboard to delete letters after cursor “|”.
In comment status, enter letters by pressing the alphanumeric key on the keyboard. Tap [Delete
Word] to delete letters before cursor “|”.
Erase All Text
• When no item is selected, press <Clear> will clear all comments and all measurements
calipers.
• After powering off, the system will clear all comments on the image.
Long press <Clear> to delete all the comments.
14.3 Voice Comments
The system supports adding voice comment to the frozen images.
To perform voice comments adding, the function should be enabled through the path: [Setup] >
[System] > [Application]. Check “Voice comment enabled”. The voice comment panel appears on
the right corner of the screen.
To Next Page
Loading...
