3 - 10 Operator’s Manual
3 System Preparation
3.8.3 Connecting a Graph/Text Printer
• Unless otherwise specified, printers listed in Chapter “2.6.4 Peripherals Supported” have
drivers installed already.
• Please refer to the accompanying manuals of the printers for more details.
As shown in the figure below, a graph/text printer has a power cord and data cable. The power cord
shall be directly connected to a wall receptacle as required.
Perform the following procedure:
1. Connect the data cable to USB port of the ultrasound device.
2. Power on the system and the printer.
3. Preset the default report printer and its attribute.
a. In B mode, click > [Setup] on the touch screen, select [Print].
b. Select the “Report Print” column in the Service Type list.
c. In the “Property” frame, select printer from the driver list next to “Printer” in the lower
screen and set the items.
d. Click [Save] after you have finished setting.
3.8.4 Connecting a Video Printer
• Unless otherwise specified, printers listed in Chapter “2.6.4 Peripherals Supported” have
drivers installed already.
• Please refer to the accompanying manuals of the printers for more details.
The digital video printers that system supports consist of the B/W printers and color printers.
Perform the following procedure:
1. Connect the data cable to USB port of the ultrasound device.
2. Power on the system and the printer.
1 Power supply cable Connect to power supply.
2 Data cable Connect to the USB port of this system.
To Next Page
Loading...
