13 - 4 Operator’s Manual
13 Display & Cine Review
Reviewing all of Auto Review
Perform the following procedure:
1. In the manual cine review status, use the [Auto Play] to set the review speed to activate auto
cine review.
2. Exit:
Tap [Auto Play] on the touch screen, or use the trackball, the auto review state becomes
manual cine review.
Setting scope of Auto Review
You can set a segment of cine loop which can be reviewed automatically.After the auto review
scope is set, the auto cine review can only be performed within this scope; but the manual cine
review can be performed beyond this scope. When the cine file is saved, only the images within this
scope are saved.
You can perform cine review on each image window in the dual/quad splitting mode, and set auto
review region for each window.
Perform the following procedure:
1. Set the start frame:
Manually review the cine file by trackball, and tap [Set Begin] on the touch screen to set
current frame to be the start point.
2. Set the end frame:
Manually review the cine file by trackball, and tap [Set End] on the touch screen to set current
frame to be end.
3. Use [Auto Play] on the touch screen to set the review speed.
The system plays the auto review region automatically.
4. In the auto cine review, press the knob under the [Auto Play] on the touch screen or rolling the
trackball will stop the auto cine review and enter the manual cine review.
5. Tap [Jump to First]/ [Jump to Last] to review the first or last image.
13.4.3 Cine Review in M/PW/CW/TVD Mode
Enter cine review in M mode, PW mode, CW mode TVD mode, and then use the trackball the cine
images are displayed on the screen one by one.
Move the playback mark to the left by using the trackball. The review progress slider moves to the
left, the images moves to the right, and the earlier stored images are invoked. Whereas move the
playback mark to the right by using the trackball, the review progress slider moves to the right, and
the images move to the left, the recently stored images are invoked. When the image goes to the
first/last frame, the cine is played in loop with the trackball moving left or right.
5 Total frames 6 Auto Review Region
To Next Page
Loading...
