4 - 36 Operator’s Manual
4 Setup
HL7 service setting for Worklist is described as follows:
4.8 Network Preset
4.8.1 iStorage Preset
You can send exam data or images to the iStorage server and perform analysis using UltraAssist.
For details about this feature, see the UltraAssist manual.
Add an iStorage service
Perform the following procedure:
1. Set the iStorage server properties as described above.
2. Click [Add] to add the service to the Service list.
Edit a network service
Perform the following procedure:
1. Select the service to be updated in the service list.
Item Description
Device After you set the server (s) in DICOM Server Setting screen, the name (s) will
appear in the drop-down list, select the name of the Worklist server.
Service Name Default is server-HL7Query, and it can be modified.
AE Title Application Entity title.here, it should be consistent with that of the HL7
server.
Port DICOM communication port, 104 by default.Here, the port should be
consistent with that of the HL7 server port.
Maximum Retries Reserved feature.
Interval Time(s) Reserved feature.
Timeout Refers to the amount of time after which the system will stop trying to
establish a connection to the service.
Listen Mode This function enables the ultrasound system to use the listen port for data
receiving.
Listen Port Port for ultrasound system to receive data after the listen mode function is
activated. Here, the port should be consistent with that of the HL7 server port.
For details of listen port setting, refer to settings in the server.
Item Description
Service Name The name of the iStorage service.
IP Address IP address of the iStorage service device.
Port Port for transmitting.
Connect Click to verify connection.
Add Click to add the Network service to the service list.
Update To save the changed parameters.
Delete Click to delete the selected service from the service list.
To Next Page
Loading...
