6 - 38 Operator’s Manual
6 Image Acquisition
1. Input the patient information.
2. Tap [iWorks] on the touch screen or press the user-defined key for “iWorks” to enter the
protocol selection screen, and tap the corresponding protocol button to enter the status.
After the system enters the iWorks screen, the available protocol is displayed on the right of
the screen.
3. Perform the scanning and saving according to the screen prompt.
4. Perform measurements or add comments/body marks to the image according to the screen
prompt.
5. After a view scanning is complete, press the [Next] on the touch screen to switch to the next
view according to the screen prompt.
6. Repeat steps 3 to 5 to acquire all the necessary images.
7. After all views are finished, the system will prompt you to exit iWorks. Tap [Yes] to exit.
6.15.1 Screen Display
The monitor displays the following screen:
6.15.2 View Operation
In iWorks status, you can perform view selection, repeat, replacement and delete operations using
the touch screen.
For some views, the system switches to the relevant imaging modes if necessary.
The comment for the current view has been automatically added to the bottom-left corner of the
image, ready for you to scan the specified anatomy.
View Selection
Tap [Prev]/[Next] to select the view to be scanned. The current view is surrounded by a solid frame.
1 Displays the protocol name, and the number of views contained.
2 Displays the view steps in the protocol.
The current active view with a solid frame around the image.
To Next Page
Loading...
