A Barcode Reader
Operator’s Manual A - 11
A.3 Maintenance
Cleaning the exit window is the only maintenance required. A dirty window can affect scanning
accuracy.
• Do not allow any abrasive material to touch the window.
• Remove any dirt particles with a damp cloth.
• Wipe the window using a tissue moistened with ammonia/water.
• Do not spray water or other cleaning liquids directly into the window.
A.4 Parameter Defaults
Refer to the following table for parameter defaults of LS2208 and DS4608.
Parameter Defaults Parameter Defaults
1-D Symbologies Interleaved 2 of 5 (ITF)
UPC/EAN Interleaved 2 of 5 (ITF) Enable Enable
UPC-A Enable Set Lengths for I 2 of 5 14
UPC-E Enable I 2 of 5 Check Digit Verification Disable
UPC-E1 Disable Transmit I 2 of 5 Check Digit Disable
EAN-8/JAN 8 Enable Convert I 2 of 5 to EAN 13 Disable
EAN-13/JAN 13 Enable Codabar (NW - 7)
Bookland EAN Disable Codabar Enable
Decode UPC/EAN/JAN
Supplementals (2and 5 digits)
Ignore Set Lengths for Codabar 5 to 55
UPC/EAN/JAN
Supplemental Redundancy
10 CLSI Editing Disable
Transmit UPC-A Check Digit Enable NOTIS Editing Disable
Transmit UPC-E Check Digit Enable
Transmit UPC-E1 Check
Digit
Enable 2-D Symbologies
UPC-A Preamble System Character PDF417 Enable
UPC-E Preamble System Character MicroPDF417 Disable
UPC-E1 Preamble System Character Code 128 Emulation Disable
Convert UPC-E to A Disable Data Matrix Enable
Convert UPC-E1 to A Disable Maxicode Enable
EAN-8/JAN-8 Extend Disable QR Code Enable
UCC Coupon Extended Code Disable
Code 128
Code 128 Enable
UCC/EAN-128 Enable
ISBT 128 Enable
To Next Page
Loading...
