Mindray Consona N6 - Page 160

7 - 12 Operator’s Manual
7 3D/4D
Reset Curve
Render Mode
The rendering manners can be applied to both gray and inversion modes.
Function: to inverse the echo of the 3D image, so as to enhance observation for low-echo region,
applicable for vessel, cyst and etc.
When the function is turned on, the rendering mode parameters change into the corresponding
inverse parameters.
Rotate the Image
NOTE:
You can view the back of the VR by rotating it 180°. The back view image may not be as vivid as
the front. (Here we call the initial view of the VR the “front”). It is recommended to re-capture
rather than rotate the VR if a certain desired region is obscured in the VR.
• Axial rotation
Axial rotation is to rotate the 3D image around the X, Y or Z axis.
Rotate the corresponding knobs to make the image rotate:
– To rotate along X-axis: rotate <M> button on the control panel clockwise, the image
rotates right along the X-axis, and rotate the button anticlockwise, the image rotates left.
Parameter Description
Reset Ori To reset the volume rotation, shifting and zooming of 3D
image to original status.
All To reset the parameters, rendering rotation, VOI and image
effect.
Curve To reset the curve to be the original beeline.
Surface Set Surface as 3D image rendering mode.
Applicable for surface imaging, such as fetus face/hand or foot.
NOTE:
You may have to adjust the threshold to obtain a clear body boundary.
Max Set Max as 3D image rendering mode, displays the maximum echo intensity in
the observation direction.
This is helpful for viewing bony structures.
Min Set Min as 3D image rendering mode, displays the minimum echo intensity in
the observation direction.
This is helpful for viewing vessels and hollow structures.
X Ray Set X-ray as 3D image rendering mode. Displays the average value of all gray
values in the ROI.
This is used for imaging tissues with different structure inside or tissues with
tumor.
iLive Add the light rendering effect based on the general rendering effect.
iLive cannot be selected as sub render mode. When it is set as main render
mode, the sub render mode is disabled.