7-5
7.3 Upgrading Functional Assemblies
You can upgrade the following functional assemblies:
Functional
assembly
PN Description Remark
6800-30-51124 SMR kit /
SMR
115-007305-00 SMR kit With a cable of 10 m.
801-6802-00030-00
6802 wireless network
upgrade kit
Internal AP,
for standard- configured
patient monitor
801-6802-00031-00
6802 wireless network
upgrade kit
Internal AP,
for fully configured
patient monitor
Wireless
network
801-6800-00002-00 Wireless network adaptor kit External AP
Recorder TR6F-30-67318 Recorder upgrade kit /
Analog
output
801-6802-00006-00 DVI interface board (FRU) /
The patient monitor can be connected to network through wireless AP. Authorized personnel
are required to connect and set up the wireless network, and then carry out the performance
test.
7.3.1 Upgrading SMR
The SMR can be connected to the patient monitor through SMR connector via a SMR cable.
Refer to the Operator’s Manual for detail.
7.3.2 Upgrading Wireless Network Function
Refer to corresponding section to install the wireless network assembly in your patient
monitor.
Refer to the Operator’s Manual for the use of wireless network.
To Next Page
Loading...
Need help?
General
