Passport V Operating Instructions 0070- 0-0704-02 3 - 3
Patient Management Setting-up Patients
Entering a Patient’s First / Last Name, ID Number and Bed Number
To enter the patient’s First Name, Last Name, ID Number and Bed Number
complete the following steps:
1. Open the Patient Menu and scroll down through the menu using the Navigator
Knob.
2. Select the patient data you wish to enter or change.
3. Press the Navigator Knob and a keypad will appear on the screen.
4. To enter patient information highlight the appropriate characters.
5. When finished entering the data select Done and press the Navigator Knob to close
the keypad.
6. The patient information will appear in the upper right hand corner of the display. This
data will also appear on printouts.
NOTE: Since Remote View requires selecting a “Bed #”, a unique
number for each bed should be used. The following
standard format for this demographic is recommended:
Patient Menu
MENU ITEM SELECTIONS COMMENTS
Normal Screen — Select to return to Normal Screen (or press the
Normal Screen key on the front panel).
Patient Size Adult (default)
Pediatric
Neonate
Note: When changing Patient Size, some patient
info may need to be re-entered.
Gender Unspecified (default)
Male
Female
Select to enter or change patient gender.
Date of Birth Unspecified (default) Select to enter or change date of birth.
First Name Select to enter or change patient’s first name.
Last Name Select to enter or change patient’s last name.
ID # Select to enter or change Patient ID.
Bed # Select to enter or change patient bed number.
Height Unspecified (default) Select to enter or change patient height.
Weight Unspecified (default) Select to enter or change patient weight.
Drug Calculator Select to open Drug Calculation Menu.
Discharge Select to discharge patient from monitor.
0
To Next Page
Loading...
Need help?
General
