Remote View Patient Management
3 - 6 0070- 0-0704-02 Passport V Operating Instructions
3.5 Remote View
The Remote View selection enables the user to view the numeric and waveform data of
another patient monitored by a different Passport V at a remote location.
To display Remote View:
On the normal screen:
Select Functions
〉 Remote View.
The Remote View feature allows the simultaneous display of data from two patients on a
single monitor. The monitor at the user’s current location is defined as the host monitor. While
maintaining visibility of the primary patient at the host monitor, the Remote View Menu
enables the user to view the numeric data and two selectable waveforms of another patient
who is being monitored at a remote location. The monitor at the remote location is defined as
the remote monitor. Visual and audio alarms occurring at the remote monitor are also
received through the Remote View Menu at the host monitor
.
FIGURE 3-2 Remote View Menu on Main Display
The “Enable Network” option in Installation Menu
〉 Advanced Installation Setup
Menu must be set to “Wired” or “Wireless” for Remote View capability to be available.
Only Passport V monitors on an approved hardwired or wireless network can be viewed
remotely.
NOTE: Unstable wireless signals may be caused by the monitor
operating beyond the network coverage, interference from
nearby equipment, or by exceeding network capacity limit.
0
To Next Page
Loading...