Minebea Intec CAS-SPC Series - Checkweighing Printout Example; Checkweighing Application Printout

“Checkweighing” Application The initialization data block contains the target weight, the minimum and
maximum load. The results block always contains the gross, net and tare weight.
Additional results can be printed in 2 dierent display types: and the piece count as
a result.
– Weight display:
In the OK and nonconforming range, the deviation from the target weight
is always printed as a percentage and absolute deviation.
– Relation to target value:
In the OK range, the deviation from the target weight is printed as a percentage
and absolute deviation. In the nonconforming range, “HH“ is printed for
exceeding the weight and “LL“ for falling below the weight.
OK range in the weight and tolerance limit display
-------------------- Nonconforming range in the weight display
Setp + 1.300 kg
Min + 1.235 kg
Max + 1.365 kg
G# + 1.312 kg
T + 0.000 kg
N + 1.312 kg
Lim + 0.92 %
Diff.W+ 0.012 kg
--------------------
-------------------- Result outside (over) “OK” range; “Threshold” printout:
Setp + 1.300 kg
Min + 1.235 kg
Max + 1.365 kg
G# + 1.400 kg
T + 0.000 kg
N + 1.400 kg
Stat HH
--------------------
Operating Instructions Combics Complete Scales 111
Data Interfaces