Minebea Intec CAS-SPC Series - External Adjustment Steps; External Adjustment Process

If gravity is being entered instead of altitude and latitude, then “Gravity“ is
displayed for a brief time after “CAL.“
The entered value appears in m/s
2
, here for the “Germany (Zone D)“ setting.
t Press J to conrm the displayed value or press ( to cancel the adjustment.
y You are prompted to place the required weight on the platform (e.g.: 5.0 kg).
The subsequent steps for completing the calibration/adjustment are described
in the chapter entitled “Operation” under “Calibration and Adjustment.“
t Slide the menu access switch to the right (= “closed“ position) and reattach the
cap.
y The display goes out and the device restarts. Then weighing mode is active.
If adjustment is carried out using a veriable conguration data record, the lines
for display of metrological data (lines 1 and 2) show the data valid for use in legal
metrology, if the menu access switch is closed. See also the chapter “Operation“,
“Conguration for Use in Legal Metrology.“
36 Operating Instructions Combics Complete Scales
Configuring Weighing Platforms