Automatic Taring
The rst weight on the scale that exceeds the preset minimum capacity is stored in
the tare memory at stability. The values for subsequent loads are stored as weight
values.
The scale returns to the initial state when the load on the scale is less than 50% of
the minimum load.
Operating Menu Setting: “Application parameters: Autotare 1st
weight:Yes“
Minimum load for automatic taring and automatic printing
To tare container weights automatically, you need to set a minimum load in the
Setup menu, under:
“Application parameters:Min. load f. auto.
taring/printout:o 10 digits
“
You can set the following for the minimum load:
1 digit (no minimum load)
2 digits
5 digits
10 digits
20 digits
50 digits
100 digits
200 digits
500 digits
1000 digits
The “digits“ here refer to the scale intervals for the connected weighing platform.
If the interval is 1 g and 1000 digits are required, the minimum load is 1000 g
(1000 intervals).
If the weighing platform interval is 5 g and the same number of digits as above are
required, the minimum load is 5000 g.
Once the minimum load has been exceeded, the weighing platform is tared
automatically and/or an automatic printout is generated.
Automatic Printing
The rst weight value that exceeds the minimum load is printed. If the menu item
is also activated for automatic taring, it is only tared when the minimum load is
exceeded. In this case, an automatic printout would only be generated when the
second weight value exceeds the minimum load.
Setting in the Setup Menu: “Device parameters:Config. printout:Once at
stability:On
“
Weighing using up to three weighing platforms
Press the n key to toggle between three weighing platforms.
Operating Instructions Combics Complete Scales 77
Operation
To Next Page
Loading...
