13
4-3-2. Switch to the calibration mode
Change from the standard measurment mode to the
stand-by condition by the key.
Pressing the key with the key pressed, it
displays .
Press the key twice.
displays.
Press the key here.
displays, and it enters into the
calibration mode.
4-3-3. Set of the scale interval
When key is pressed twice from
display, is displayed.
“ ” is the scale interval being memorized now.
Please select the scale interval from 1, 2, 5, 10, 20 or 50.
：Selects the scale interval.
：Setting is interrupted and returns to
display.
：The displayed value is memorized, and
proceed to the next step.
Press the key after the set.
The scale interval to be used.
Move to the setting of the scale interval.
Calibration mode
Stand-by condition
＋
Move to set weighting.
The scale interval being memorized now.
To Next Page
Loading...