54
11-3-2. Setting for upper limit value/lower limit value.
By pressing the key from the normal measurement
mode, it becomes the stand-by condition.
By pressing the key with the key,
is displayed with blinking
By pressing the key, the upper limit (HI) being
memorized at present is displayed, and please set the
upper limit key by using the following keys.
: Change the value of the changed digit.
: Select the changed digit
: Change the display value to “0”.
: Setting is interrupted, and returns to the
display.
: Memorize the display value and proceed to
the next step.
: The upper/lower limit setting is finished
without changing all setting.
After the upper limits value(HI) is completed, and when
the key is pressed, the setting value is memorized
and display blinks.
When the key is pressed, as the lower limit value
(LO) memorized at present is displayed, please set as
above upper limit value.
After the setting of the lower limit value is completed,
please press the key to memorize the setting value,
and display blinking again.
Upon completing the setting of the upper/lower limit
value, press the key, and move to the stand-by
condition.
Upper/lower limit setting mode is finished.
Measurement mode
＋
Memorize the
set value.
Memorize the
set value.
To Next Page
Loading...
Need help?
General
